TeamViewer 9 Manual Wake-on-LAN of 13Ħ Set up Windows Note: Administrative rights are required for this process. It may be necessary to adjust the properties of the network card for this purpose. 3.2 Configure the network card The computer's network card must be configured in such a way that it is supplied with power at all times. Note: If there is no option to activate Wake-on-LAN in the BIOS, check the manual of the motherboard to make sure that it supports Wake-on-LAN. Press the F2 key (or the equivalent) to access the BIOS set-up. To activate Wake-on-LAN in the BIOS, follow these steps: 1. This procedure can differ from computer to computer. 3.1 Configure the BIOS It may also be necessary to activate Wake-on-LAN in the computer BIOS. Several settings must be adjusted on the computer for this purpose and TeamViewer must be correctly configured. TeamViewer 9 Manual Wake-on-LAN of 13ĥ Set up Windows 3 Set up Windows In order to wake up the computer, it must be appropriately set up. If these requirements have been met, you can move on to configure your computer and the software in the next steps. The computer is in one of the following power states Sleep Start > Sleep Hibernation Start > Hibernation Shut down (Soft off) Start > Shut down not supported under Mac OS X Supported power states. The computer is connected to the Internet via a network cable. The computer's network card supports Wake-on-LAN. The following checklist ensures that the computer is suitable for Wake-on-LAN: The computer is connected to a power source. TeamViewer 9 Manual Wake-on-LAN of 13Ĥ Requirements 2 Requirements In order to successfully wake up a computer by Wake-on-LAN, its hardware must meet several requirements. Unless stated otherwise, the functionalities described always refer to the TeamViewer full version for Microsoft Windows. This manual describes the necessary requirements and steps to use TeamViewer Wake-on-LAN. Wake up a computer via its public address (see section 5.3, page 10). Wake-on-LAN can be used through two different methods: Wake up a computer via another computer within the same network (see section 5.2, page 9). This way, you can control an offline computer remotely by waking it up before you establish a connection. 3 About Wake-on-LAN 1 About Wake-on-LAN You can turn on an offline computer with TeamViewer via Wake-on-LAN.
0 kommentar(er)
